Go Back   Professional Soldiers ® > Special Forces Weapons > Ammo Talk

Reply
 
Thread Tools Display Modes
Old 06-26-2014, 06:08   #1
Longstreet
Guerrilla
 
Longstreet's Avatar
 
Join Date: Jun 2008
Location: Canada
Posts: 333
Modified Target for .22 Shooting.

I need some help. Last year I purchased a .22 bullet trap to use when shooting paper targets. During this time I had many issues with the rounds shattering upon impact and driving holes in my targets. I also had problems with the wind moving my targets as well some I had problems with attaching the targets (my bullet trap came with a clipboard clamp, but it took a few rounds and was rendered useless).

So in an attempt to correct this I have attached a wooden frame around the bullet trap and then routered a slit so that I can slide a piece of compressed cardboard - which I will use to attach my targets. By doing this I have solved all of my problems with moving targets and how to attach them. The compressed cardboard is cheap so it will be replaced as needed.

The new problem I now have is that by using a wooden frame, should it get hit it will not hold up. To solve this, I am planning on attaching steel pieces to all wooden parts. And this is where I need help. Given my limited knowledge of .22 ballistics, would it be safe to do this? I have a limited shooting range and will be approximately 20-30 yards from the target. I will be shooting a bolt action Marlin with only iron sites and of course I will be wearing eye protection. Do I need to worry about any ricocheting with my mods? Is there anything else I should be concerned about? Comments or suggestions?
Attached Images
File Type: jpg 20140626_080425.jpg (226.2 KB, 56 views)
File Type: jpg 20140626_080407.jpg (285.4 KB, 57 views)
__________________
I’ve come to a frightening conclusion that I am the decisive element in the classroom. It’s my personal approach that creates the climate. It’s my daily mood that makes the weather. As a teacher, I possess a tremendous power to make a child’s life miserable or joyous. I can be a tool of torture or an instrument of inspiration. I can humiliate or heal. In all situations, it is my response that decides whether a crisis will be escalated or de-escalated and a child humanized or dehumanized.
--Haim Ginott--

Last edited by Longstreet; 04-17-2021 at 00:03.
Longstreet is offline   Reply With Quote
Old 06-26-2014, 07:29   #2
Peregrino
Quiet Professional
 
Peregrino's Avatar
 
Join Date: Jun 2004
Location: Occupied Pineland
Posts: 4,701
Longstreet - a few points off the top of my head:

1. Wood is used because it is replaceable if damaged and doesn't cause ricochetes. Do not put metal guards over your wooden frame. Do not construct the wooden frame so that it obscures the bullet trap. You're inviting more misses if you can't clearly identify the "target zone".
2. Your cardboard backer will last longer if you cut holes in the cardboard under the "bulls".
3. Use .22 Longs. If you're using .22 LR, stick with SV (standard velocity). Don't use Mini-mags or similar. You're shooting a bolt gun, with care during the feeding cycle it'll handle anything, even shorts. You don't need "magnum" rounds for target practice.
4. Do not exceed 10 meters unless you're using optics. That's all that bullet trap was intended for.
5. At this stage you'll probably get more value out of practicing with an air rifle - it's a lot more difficult (NTM safer and cheaper) than you think.
__________________
A nation can survive its fools, and even the ambitious. But it cannot survive treason from within. An enemy at the gates is less formidable, for he is known and carries his banner openly. But the traitor moves amongst those within the gate freely, his sly whispers rustling through all the alleys, heard in the very halls of government itself. For the traitor appears not a traitor; he speaks in accents familiar to his victims, and he wears their face and their arguments, he appeals to the baseness that lies deep in the hearts of all men. He rots the soul of a nation, he works secretly and unknown in the night to undermine the pillars of the city, he infects the body politic so that it can no longer resist. A murderer is less to fear.

~ Marcus Tullius Cicero (42B.C)
Peregrino is offline   Reply With Quote
Old 06-26-2014, 21:12   #3
Longstreet
Guerrilla
 
Longstreet's Avatar
 
Join Date: Jun 2008
Location: Canada
Posts: 333
Peregrino,
Thanks for the response. I am going to respond to each of the points you made.

Quote:
1. Wood is used because it is replaceable if damaged and doesn't cause ricochetes. Do not put metal guards over your wooden frame. Do not construct the wooden frame so that it obscures the bullet trap. You're inviting more misses if you can't clearly identify the "target zone".
The clip my bullet catcher came with was ruined when I was honing in a new scope for a different .22 that I own. I made the wooden frame to make it easier to post my targets and to solve the issues I was having with the wind and the shattered bullets. When using my iron sites I am a decent shot and while I am not shooting constant bullseyes, my rounds do hit the intended targets and land safely in my bullet catcher. I was contemplating the steel plating only to preserve the wood in the event I have an 'oops'. Obviously safety is paramount which is why I posted this question before using my bullet catcher. I thought it might be easier to just install the steel plates rather than carry a couple 2x4's. From your input, I will not be using any steel plating. Instead I will carry a few extra 2 x 4's just in case I goof.


Quote:
2. Your cardboard backer will last longer if you cut holes in the cardboard under the "bulls".
I had not thought of that, but will pull out my jigsaw and change my backer.

Quote:
3. Use .22 Longs. If you're using .22 LR, stick with SV (standard velocity). Don't use Mini-mags or similar. You're shooting a bolt gun, with care during the feeding cycle it'll handle anything, even shorts. You don't need "magnum" rounds for target practice.
Yup. Nothing special going into my rifle - especially given the level of shooting I do. I use the standard .22 LR ammunition that goes for about $25 a brick. I do prefer rounds that are not hollow point as my other .22 has had a few issues with such bullets.

Quote:
4. Do not exceed 10 meters unless you're using optics. That's all that bullet trap was intended for.
For my first .22 I bought a Savage and made it real tacticool. I will admit I am a sucker for the tactical look and set up my rifle with a bipod and scope. And while I love shooting it, I find it very heavy and can only shoot it while in the prone position. Since my current setup is about 20-25 yards, the scoped gun was total overkill. So I purchased another bolt action, but this one I want it keep stock so I can better hone my skills using just iron sights.

Quote:
5. At this stage you'll probably get more value out of practicing with an air rifle - it's a lot more difficult (NTM safer and cheaper) than you think.
I have grown up with plinking various air rifles and wanted to move onto an actual firearm. For the amount of time I actually get in to shoot I probably should have just stayed with the air rifles, but I really wanted to start firing real (for lack of a better word) firearms. Shooting handguns in Canada is a PITA so I still do make use of airguns albeit pellet handguns.

Again Peregrino thank you so much for your time and help. I do greatly appreciate it.
__________________
I’ve come to a frightening conclusion that I am the decisive element in the classroom. It’s my personal approach that creates the climate. It’s my daily mood that makes the weather. As a teacher, I possess a tremendous power to make a child’s life miserable or joyous. I can be a tool of torture or an instrument of inspiration. I can humiliate or heal. In all situations, it is my response that decides whether a crisis will be escalated or de-escalated and a child humanized or dehumanized.
--Haim Ginott--

Last edited by Longstreet; 04-17-2021 at 00:06.
Longstreet is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Forum Jump



All times are GMT -6. The time now is 11:30.



Copyright 2004-2022 by Professional Soldiers ®
Site Designed, Maintained, & Hosted by Hilliker Technologies