Quote:
Originally Posted by fng13
I am using the burris P.E.P.R. Mount, it is a single mount with 2 built in rings like a larue spr mount. It does only tighten on the left, which I thought was probably causing the problem but I dont think that I am overtightening it because I am only hand tightening it, I tried to leave it a little loose but with no success.
As per the gunsmithing, this will probably end up being what I do, but I'm broke so the temptation is strong to try and remove the handguard and check it myself. I did not cross thread the barrel nut, I know that for sure. What does it mean to have the nut out of alignment?
Also, I am unsure how to find a good gunsmith. Gander mountain has one, but they charge a hefty sum, as I had looked at them doing it before. I have put a lot of money and time into this build and don't want to pass it off to just anyone.
Thanks again.
|
FNG:
One thing I forgot to ask.
Did you zero the upper using any iron sights? If you did zero it with a set of irons and had no problems with windage, something is wrong with the scope mounts or optic.
If you have a set of irons, slap them on and try to zero. If the same thing happens, the barrel was put on crooked.
You didn't have problems posting to this forum. What makes you think you will have any problems finding someone who is competent at making AR-15's? Come on guy...
Gene