Quote:
Originally Posted by kpdarnell
I am back.
The case is pretty much completed so now comes more questions.
Has anybody here had any luck in finding a private lab to try and raise the serial number? I am guessing no, since I haven't been contacted in awhile now.
If I can't get the serial number lifted and the knife returned to a rightful owner then I intend to clean the knife up, sharpen it, get a sheath, sign it out from evidence and use it at work.
My concern is the spot where the serial number was has been ground down pretty deep. It may have substantially weakened the blade.
Does anybody have another idea in locating the owner or an heir?
|
I'm pretty sure you will not be able to "raise the serial number" by acid etching because that only works for steel that has had the serial numbers stamped in.
All Yarboroughs serial numbers are engraved to avoid the stress risers caused by stamping and engraving has very little impact on the grain structure underneath.
How the serial numbers were ground off will determine how strong the blade remains. All tool steels in this class are to one degree or another notch sensitive.
If the knife is wrecked you may as well carry it until it can't be carried but if your life depends on a knife, get a good one that isn't f*cked up.