35mm Lever Rings

[P-Squared]

I purchased a Vortex Razor 5-20x50 with a 35mm tube. Has anyone seen ARMS #22-34mm Lever Rings or equivalents? I am trying to keep from a one piece base if possible. I'm planning to run a 20 MOA base on a new POF .308 that's coming in April. Anny suggestions would be greatly appreciated.

[JJ_BPK]

Ok CSSBB..

You failed to read your email from the site. Go read it again, also read the sticky in the INTRODUCTION sub-fora, then use the Search button, prodigiously..

Do not post for a good while, least you incur the wrath of the Mods...


Welcome to PS.com

[Peregrino]

Interesting. Most 20 MOA bases I know of are for bolt guns. Most AR platforms don't use bases - the rail on the receiver is all that's required. Most ARs, e.g. POF, have 0 MOA rails (the Larue OBR is an exception, it has 20 MOA built into the receiver). Individuals needing 20 MOA on an AR platform usually use an appropriate one piece base; it saves stacking an angled base on top of the AR. An example of an angled one-piece base is the Larue Tactical LT-158 http://stores.homestead.com/Laruetactical/Detail.bok?no=42. Just a suggestion.

For another suggestion - I recommend you re-read the email you recieved when you registered and comply with it. Your first post is supposed to be an introduction; not a new thread asking a question that has been discussed previously. FTFSI is not a good way to make our acquaintance.

[longrange1947]

I would not buy A.R.M.S. junk on a bet. Look at the LaRue stuff and go that way.

Hope you have read and heeded the email as another post without intros and reading the search results could get ugly.

For some reason all are plotie today. :munchin